When you buy the doors you should ensure that you read the instruction kit that always accompanies them.

The kit will guide you on how to properly install and take good care of your door. If you want to learn how to install your barn door, here are the steps that you should follow:

The first thing that you should do is to measure and cut two lengths of the mounting board for each of the doors. The boards that you cut should be the same length as the doors and 4 cm wider than the track.

Once you have cut the boards you should attach the mounting boards to the top and bottom of the doorway. You should ensure that the mounting boards run straight along the doorway.

You should then measure and cut two lengths of track for each of the barn doors and then use joint brackets to attach the required track sections. You should ensure that the tracks are the same length as the section along which you want the door to slide.

If installing two sliding doors, you should ensure that the tracks are twice as wide as each of the doors so that you are able to slide them together on one track. If you are installing one door, the track should be the same width as the door.

When placing the brackets you should ensure that they occur every 6 inches and they are located in the middle of the track. If attaching the track to softer or weaker material, you should measure more holes.

You should then drill holes into the tracks and mounting boards then use spacers and bolts to attach the two together.

By reading the instruction kit, you should be able to securely hang rollers in the right places. You should also be able to attach any washers and bolts then mount the doors.